These fans came with my case and I didn't know they were 3-pin when I bought the FH-10. The pinouts for the 4 pin fan cable connector are: Apple Motherboard 4 pin CPU PWM fan connector pinout Apple Motherboard 4 pin CPU PWM fan connector pinout HP Server 5 pin Fan connector pinout Motherboard 4 pin CPU PWM fan connector pinout Motherboard 4 pin CPU PWM fan connector pinout There is one linked connector - 4 pin motherboard fan. They can be used to power RGB panel or other appliance. Fans and on-board fan headers are backwards compatible. 4-pin connectors are usually used by CPU fans with higher power consumption. 3-pin connectors are usually used for the smaller chassis fans with lower power consumption. The question is: If I connect the air cooler into the first input of FH-10 fan hub, along with case fans in the remaining inputs (2-4) and then plug the PWM cable from FH-10 into my CPU_FAN header, will my case fans speed be adjusted according to my CPU fan? 4 pin molex connector is commonly used to connect power to RGB panel. Chassis and CPU fans may use either 3-pin or 4-pin power connectors. /rebates/&.com252fbuy252fmotherboard-4-pin-fan-pinout. However, my CPU Air Cooler (Hyper 212 Black) is connected by 4-pin into the CPU_FAN header in the motherboard and I can control the speed inside the BIOS. Because of that, I can't control the speed of my fans in BIOS using DC voltage due to PWM connection of FH-10, so they all are at full speed and quite loud. I have a case with 4 ARGB fans (all 3-pin) connected to my fan hub (Deepcool FH-10), which only controls the first input of a PWM fan.
0 kommentar(er)
